100 Series (end brackets are 4"h X 5"w)

1. Roll Window Quilt all the way up.
   Lower 2”- 3” and lock in place with cord lock (pull cord toward center of the shade)
    
2. Bend batten stop forward about  ½”
    
3. Remove seal roller (rear roller) by lifting one end of the roller out of the slot in the bracket
    
4. Thread the end of the quilt side cord into the top of the track guide CAREFULLY. Make sure it does not snag on the track guide
    
5. Replace seal  roller
    
6. Bend batten stop back to its original position
    
7. Raise and lower quilt several times to make sure it functions correctly

400 Series (end brackets are 6"h X 4"w)

1. Roll Window Quilt all the way up
    

2. Lower shade 2” – 3”
    

3. Loop the pull cord around the end bracket and tie the cord off so the shade stays up
    

4. Loosen the lower bracket screw on the side that does NOT have the pull cord and slide the bracket away from the center of the shade
    

5. Remove the seal roller from the brackets (NOTE: pull cord is still attached to the seal roller)
    

6. Thread the end of the quilt side cord into the top of the track guide CAREFULLY.
    

7. Make sure it does not snag on the track guide
    

8. Install the seal roller to its original position